Radial Engineering Switchbone V2 handleiding

Niet gecategoriseerd

Radial Engineering

20 pagina's

PDF beschikbaar

Handleiding

Switchbone V2

Radial Engineering Ltd.

STANDARD ABY SETUP

To test the signal path, connect your guitar to the INPUT and OUT-A to

your main amp. Check to make sure the OUT-A LED is illuminated. Turn

up your guitar and then turn up your amp slowly to ensure the signal is

passing. You can now connect your second amp and test by toggling

between the two amps using the middle AB footswitch. For fun, combine

both amps using the BOTH footswitch.

Example:

When amp 1 is on, the channel A LED next

to the TOGGLE switch will be lit.

Depress the BOTH switch and the 2nd

channel is now activated. The new channel

LED will ash.

Hit the TOGGLE footswitch and the ashing

LED will toggle between the two channels.

To go back to single channel operation,

depress the BOTH switch again and the

ashing channel will go off.

You will note that when you hit the BOTH footswitch, one of the LEDs will

begin to ash. This TOGGLE mode function is designed to let you know

in advance what will happen when you hit the BOTH footswitch again

whereby the ashing LED will be the one that goes off. You can toggle

the ashing LED by depressing the AB selector footswitch so that when

you return to single amp playing, you can ensure the amp that you want

on will be the one that is active.

Bekijk gratis de handleiding van Radial Engineering Switchbone V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.