Radial Engineering Switchbone V2 handleiding

Niet gecategoriseerd

Radial Engineering

20 pagina's

PDF beschikbaar

Handleiding

OUT-A

Amp 1

OUT-B

Amp 2

Press 'IN' the 180º

to reverse the phase

of OUT-B to bring the

two amps in phase.

Switchbone V2

Radial Engineering Ltd.

When both amps are on, there are two things to watch for… the rst

is noise, the second is phase. If you hear noise, try depressing the

ground lift switch on OUT-B. This works in conjunction with the isolation

transformers to eliminate hum and buzz caused by ground loops. This

lifts the audio ground, not the electrical safety ground.

When using two different ampliers, these will often be out of phase

whereby one amp will be pushing the speaker forward while the other

will be pushing it backwards. This causes phase cancellation that is

most noticeable in the low end and can make the amps sound distant.

To test, face your two amps together (speaker to speaker) and listen.

Try depressing the 180º polarity reverse switch on OUT-B to hear the

difference.

ADDING A TUNER OR THIRD AMP

You can add a tuner to your setup using the dedicated TUNER out. This

output is both buffered and transformer isolated to ensure clocking noise

from the tuner is not audible in the guitar signal path. This also permits

the tuner out to be reassigned as a third amp when required.

Bekijk gratis de handleiding van Radial Engineering Switchbone V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.