Radial Engineering Switchbone V2 handleiding

Niet gecategoriseerd

Radial Engineering

20 pagina's

PDF beschikbaar

Handleiding

BOTH/OUT-C

In the OUT

position

TOGGLE/BOOST

In the OUT

position

180° and LIFT

In the OUT position

for both outputs

Switchbone V2

Radial Engineering Ltd.

MAKING CONNECTIONS

Before making connections, always ensure the volume levels on

your amps are turned off as this will avoid power-on and plug-in

transients that could reduce the lifespan of your speakers and other

sensitive components. Connect the included 15VDC power supply

to the Switchbone V2. There is no power switch, as soon as power is

connected, you will see one of the LED’s illuminate and it will spring

to life. The Switchbone V2 is equipped with a cable lock to secure the

power supply into place. Simply loosen the hex screw and pass the

power cable through the clamp in a compact loop.

Set all of the controls and switches to the start position:

IMPORTANT

OUT-A is your primary output and should always be used. It should be connected

to an amp that is properly grounded with a three prong U-ground for safety. Never

remove the safety ground on your amp as this is both illegal and there to protect

you from an electrical shock. Please consult your local electrical authority or

qualied electronic technician for more details.

Bekijk gratis de handleiding van Radial Engineering Switchbone V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.