Rademacher RolloTube S-line Zip DuoFern SLDZM handleiding

Niet gecategoriseerd

Rademacher

64 pagina's

PDF beschikbaar

Handleiding

Reset the original connection in accordance with the connection diagram [ 19 to 21 ] on pages 52 to 53

if you have carried out the setting with the universal setting cable.

In the event that a malfunction occurs during the setting process, e.g. the tubular motor only runs for a

single rotation even when you press and hold the set button, the adapter (4) may have slipped oﬀ the

drive head (3).

◆ If necessary, check and correct the positioning of the adapter (4), see page 59.

10. Manual adjustment of end points

10.1 Test run / modifying the end points

Test run

1. Subsequently check the direction of travel if the

RolloTube S-line Zip DuoFern is being operated

using a switch or button.

Switch the lines for the rotation direction if the di-

rection of travel is wrong, see connection diagram

[ 20 / 21 ] on page 52 / 53 .

2. Check your settings and allow the screen to run in

both directions until the end points switch oﬀ the

motor.

Modifying the end points

Move the screen back to the centre position and

begin the process again.

ATTENTION!

The tubular motors are designed for transient

operation (approx. 4 min.).

If this period is exceeded, or if the equipment is

switched over frequently, then the motor may heat

up and the thermal protection system will switch

it oﬀ.

◆ In this case, allow the motor to cool down for 20

minutes.

Bekijk gratis de handleiding van Rademacher RolloTube S-line Zip DuoFern SLDZM, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.