Rademacher RolloTube S-line Zip DuoFern SLDZM handleiding
Handleiding
Je bekijkt pagina 56 van 64
56
EN
With the universal
setting cable
10. Manual adjustment of end points
2. Move the screen to the desired direction, e.g. up-
wards, if the upper end point is to be corrected.
3. Press/tap twice briefly and press and hold the third
time.
4. Release the button again as soon as the desired
end point is reached.
5. You can adjust the end point in small steps by
briefly pressing the button.
6. Switch off the specified direction of travel after
successfully setting the end points.
Briefly move the motor in the opposite direction to
store the end point.
Direction of travel 1
Set the rocker switch to the centre position.
Direction of travel 2
II
I
III
III
III
II
I
or
1. First, switch on the mains power or continuous
phase at the universal setting cable.
The LED on button 3 must light up
continuously.
ON/
SET
8. Then switch off the continuous phase on
the universal setting cable.
ON/
SET
ATTENTION!
When setting the end points, a combination with a
DuoFern radio remote control can cause malfunc-
tions.
7. Check your settings and allow the screen to run in
both directions until the motor switches off at the
end points.
II
I
Direction of travel 1
Direction of travel 2
Bekijk gratis de handleiding van Rademacher RolloTube S-line Zip DuoFern SLDZM, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Rademacher |
| Model | RolloTube S-line Zip DuoFern SLDZM |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7643 MB |
