Protector AS-7040 handleiding
Handleiding
Je bekijkt pagina 34 van 92
open’ signal is only produced once the roller shutter
is completely open.
Proceed as follows to attach the roller
shutter transmitter:
1. Mount the lower casing section of the roller shutter
transmitter to the correct position using the included
double-sided sticky pad.
Alternatively there is a prepared hole in the lower casing
section to screw the roller shutter transmitter onto the
window frame. To use this carefully remove the printed
circuit board from the lower casing section and screw
the casing in place using the included screw. Then
carefully replace the printed circuit board.
2. Insert the battery (1x size CR2477) into the
transmitter with the correct polarity and fix it in place.
NOTE
Please ensure that you lay the battery in the
window transmitter on top of the metal tab and
not below it.
3. Press the upper casing section onto the lower
casing section.
Attaching the magnet
Fix the magnet in place in accordance with figure 4.
Open and close the roller shutter once after attachment.
The transmitter should flash at least once for each
activation. Proceed as follows to attach the magnet:
4. Attach the lower magnet casing section and the lower
sensor casing section in the correct position using the
included double-sided sticky pad.
Alternatively there is a prepared hole in the lower casing
sections through which the magnet and the sensor can
be screwed to the window frame.
5. Drill a 5 mm hole through the window frame and feed
the sensor cable to the outside into the lower casing
section at the correct point.
6. Insert the magnet and the sensor and check the
functioning of the roller shutter sensor.
CAUTION!
The distance between the roller shutter sensor and
the magnet may not exceed 6 mm!
7. Open the roller shutter again. The green LED (OPEN)should
flash briefly if the sensor has been installed correctly.
8. Now close the roller shutter. The red LED (CLOSED) will
flash briefly.
9. After all functions have been successfully tested the
transmitter, sensor and magnet must be screwed to the
window/window frame. There is a prepared hole in the
lower casing section of the roller shutter transmitter and
in the lower casing of the magnet and sensor. This allows
you to screw the roller shutter transmitter, magnet and
sensor to the window/window frame. This prevents them
from falling down unintentionally during operation.
EN
34
Bekijk gratis de handleiding van Protector AS-7040, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Protector |
| Model | AS-7040 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8838 MB |
