Proline 66471 Handleiding (76 Pagina's)

Handleiding

7

PROBLEM POSSIBLE CAUSE SOLUTION

a) Too low working pressure.

The tool's rpm is two low or it does not

start.

b) Pollution inside the tool housing.

The tool starts and then slows down. Too low compressor capacity Connect the device to the more efficient compressor.

a) Check if the pressure hose is not twisted or clogged;

Increase the work pressure to 0.63 MPa;

b) Insert a small amount of a maintenance fluid (e.g. WD-40) by

the air inlet opening. Switch the tool on for about 30 seconds.

This will enable to spread the maintenance fluid inside the tool

and clean it.

PLEASE NOTE! WD-40 may not be used as the lubricating oil proper.

The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the

company reserves the right to make amendments to the product specification without a prior notice. The images

included into the operation manual are only of the exemplary nature and may slightly differ from actual appearance

of the device purchased.

This instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is

prohibited.

waste containers as they may contain substances hazardous for human health and the environment!

Households should contribute to recovery and recycling of worn tools. Please provide active help with respect to economical use of natural resources and

natural environment protection by taking the worn tool to the worn tool collection centre. To reduce the waste amount, it is necessary to reuse, recycle or

recover it in any other way.

TROUBLESHOOTING GUIDE:

Please stop using the tool immediately after you have detected any defect. Operating damaged tool may cause injuries. Any tool repairs or replacements

must be carried out by the qualified personnel in the authorised repair workshop.

Bekijk gratis de handleiding van Proline 66471, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.