Phoenix Contact FL PN/PN SDIO-2TX/2TX Handleiding (94 Pagina's)

Handleiding

Mounting, removal, electrical installation, and replacement

8220_en_06 PHOENIX CONTACT 39

Figure 3-1 Mounting the FL PN/PN SDIO-2TX/2TX

1. Place the groove of the device onto the DIN rail from above (A in Figure 3-1).

2. Push the bottom of the device towards the DIN rail until the spring-loaded holder

engages with a click (B in Figure 3-1).

3. Finally, make sure that the device is securely mounted on the DIN rail.

3.3 Removing the FL PN/PN SDIO-2TX/2TX

To remove the device, follow the instructions in “Replacing the FL PN/PN SDIO-2TX/2TX”

on page 42.

3.4 Connecting the Ethernet interfaces

Use Ethernet cables according to CAT5 of IEEE 802.3.

A

B

WARNING:

Since it is possible for two PROFINET/PROFIsafe networks coupled via the safe

PROFINET gateway to cover the same address areas, please take measures to prevent

the RJ45 plugs on the device being mixed up. If this cannot be achieved adequately, the

F-Addresses must be uniquely assigned within the PROFINET/PROFIsafe networks

coupled by the safe PROFINET gateway.

Observe the notes on color coding and security elements for patch cables in “Connecting

the Ethernet interfaces” on page 39 and “Accessories” on page 65.

Bekijk gratis de handleiding van Phoenix Contact FL PN/PN SDIO-2TX/2TX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.