Phoenix Contact FL PN/PN SDIO-2TX/2TX Handleiding (94 Pagina's)

Handleiding

FL PN/PN SDIO-2TX/2TX

34

PHOENIX CONTACT 8220_en_06

The following values are preset by default:

Switches F1, F2 (10-pos.) Only set addresses in the range from 1

dec

(01

hex

) to 1000

dec

(3E8

hex

).

2.10 Ethernet interfaces

Figure 2-8 Ethernet interfaces X1, X2 (A) and X3, X4 (B)

Four standardized Ethernet interfaces in the form of RJ45 sockets are available for

connecting the Ethernet network.

Interfaces X1/X2 (A) are assigned to PROFINET system 1 and are switched inside the

device. Interfaces X3/X4 (B) are assigned to PROFINET system 2 and are switched inside

the device.

DIP

switch

Address Setting

F1 F_Dest_Add (1) for

PROFINET system 1

All switches set to “1”: invalid setting

F2 F_Dest_Add (2) for

PROFINET system 2

All switches set to “1”: invalid setting

Switch (bit value) Position Value

1 (LSB) ... 10 (MSB)

0 (off) “0”

1 (on) “1”

L

N

K

1

A

C

T

1

L

N

K

2

A

C

T

2

L

N

K

3

A

C

T

3

L

N

K

4

A

C

T

4

X

1

X

2

X

3X

4

PROFIsafe

c

FL

PN/PN

SDIO-2TX/2TX

Ord. No. 27 00 651

M

AC

Address

A

B

Use an Ethernet cable according to CAT5 of IEEE 802.3.

When working on PROFINET/PROFIsafe and its components, the following documents

must always be available and observed at all times.

– PROFINET Installation Guideline for Cabling and Assembly

– PROFIsafe System Description

– PROFIBUS Guideline, PROFIsafe Policy

– PROFIsafe – Environmental Requirements Guideline

These documents are available on the Internet at profinet.com

or you can contact your

local Phoenix Contact office regarding these documents (see also “Documentation” on

page 66).

Please also observe the relevant information on PROFINET and PROFIsafe, which is

available on the Internet at profisafe.net.

Bekijk gratis de handleiding van Phoenix Contact FL PN/PN SDIO-2TX/2TX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.