Phoenix Contact ECM-UC-100A-UI Handleiding (80 Pagina's)

Handleiding

Configuration

111433_en_00 Phoenix Contact 33 / 78

4.1.7 Setting the analog output (only for devices with analog output)

Figure 4-11 Settings for analog output

Output type

Select one of the standard signal ranges.

The following ranges are available:

Source

Specify which current type should be mapped to the analog output:

– I RMS

– I AC

– I DC

Measurement range start value and end value

Specify the current value in amperes from which the measurement starts and ends. If you

have selected “I RMS” or “I AC” as the source, the lowest value is 0 A. If you have se-

lected “I DC” as the source, you can also specify a negative value as the start value.

Over range detection and under range detection

Select “Over range detection” or “Under range detection” to define an individual current

limit value in ampere at which a freely defined current level is output in milliampere.

Table 4-2 Output type standard ranges

Current ranges Voltage ranges

0 mA ... 20 mA 0 V ... 10 V 2 V ... 10 V -10 V ... 10 V

20 mA ... 0 mA 10 V ... 0 V 10 V ... 2 V 10 V ... -10 V

4 mA ... 20 mA 0 V ... 5 V 1 V ... 5 V -5 V ... 5 V

20 mA ... 4 mA 5 V ... 0 V 5 V ... 1 V 5 V ... -5 V

Bekijk gratis de handleiding van Phoenix Contact ECM-UC-100A-UI, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.