Parkside PWDS 920 C3 handleiding
Handleiding
Je bekijkt pagina 11 van 48
PWDS 920 C3
■ 8
│
GB
│
CY
Before use
WARNING! RISK OF INJURY!
► Always remove the plug from the power
socket before working on the tool!
CAUTION!
► Wear protective gloves when changing
tools.There is a risk of injury if the accessory
tools are touched.
Selecting a sanding sheet
Removal and surface
The material removal rate and surface quality are
determined by the grain of the sanding sheet.
♦ Please note that you need to use sandpapers
with different grains for working different
materials.
In the table below, you will find some recom-
mended values which will help you determine
which sanding sheet p to use for which job.
Wood
Sanding
sheet/grain
Working wood 80–240
Pre-sanding of unfinished,
unplaned beams and planks,
for example
80
Surface sanding 80, 100, 120
Fine sanding of hardwoods 180, 240
Paint/varnishes
Sanding
sheet/grain
Working on coats of paint/
varnish or primers such as filler
80–240
Removal of paint 80
Sanding undercoat 80, 100, 120
Final sanding of primers before
painting
180, 240
Changing the sanding sheets
The surface of the sanding plate w consists of
a hook and loop fabric so that you can fasten
sanding sheets p quickly and easily.
♦ Before attaching a new sanding sheet p,
remove dirt and dust from the sanding plate w,
e.g. with a brush.
♦ Place the sanding sheet p flush against the
edge of the sanding plate w. Then place the
sanding sheet p on the sanding plate w
and
press it down firmly. Make sure that the extrac-
tion holes on the sanding sheet p and the
sanding plate w match up.
♦ To remove the sanding sheet p, lift the edge
and pull it off the sanding plate w.
Assembling the tool
♦ Close the hinge on the retaining clip 1. Fix the
tool using the retaining clip 1. Note the
symbols on the retaining clip 1.
♦ Insert the appropriate end of the extension
tube 4 into the appropriate opening of the
control unit 2.
♦ Fix the extension tube 4 in the desired position
using the tube clamp q. Take care not to
exceed the maximum mark on the extension
tube 4.
Installing the dust extraction system
Dust from materials such as lead-based paints,
some types of wood, minerals and metal can be
harmful to health. Touching or inhaling the dusts
may cause allergic reactions and/or respiratory
illnesses of the user or people in the vicinity.
Certain dusts such as oak or beech dust are consid-
ered carcinogenic, especially in combination with
wood treatment additives (chromate, wood pre-
servatives). Materials containing asbestos may
only be worked on by specialists.
■ Always use a dust extractor.
■ Operate the power tool either with a dust bag
or connect a dust and chip extraction device.
■ Ensure that your workplace is adequately venti-
lated.
Bekijk gratis de handleiding van Parkside PWDS 920 C3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PWDS 920 C3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5343 MB |
