Parkside PTPK 400 C1 handleiding
Handleiding
Je bekijkt pagina 24 van 47
24
GB/IE/NI/CY
Maintenance and Cleaning
Cleaning
NOTE! RISK OF DAMAGE!
Improper handling of the appliance can result in
damage to the appliance.
Do not use any aggressive cleaning agents,
brushes with metal or nylon bristles or sharp or
metallic cleaning objects, such as knives, hard
spatulas, and the like. These can damage the
surfaces.
Where the appliance is deployed in an unfixed,
non-stationary setting, the appliance must be
cleaned following every use.
Disconnect the appliance from the power
supply.
Use the retaining cable
13
to pull the appli-
ance out of the water.
Remove the pressure hose, the adapter
9
as
well as the connecting piece
12
.
Clean away any soiling that may have oc-
curred in the suction area
4
.
Clean all parts (except the power plug) with a
cloth and clean water.
Use a soft brush to perform additional cleaning
of all stubborn contaminants.
Rinse the appliance with clean water.
Maintenance
- Check the condition of the retaining cable
13
. Exchange the retaining cable if it is brittle or
worn.
For fixed installation (every 3 months):
- Test the float switch
5
for proper functioning.
- Clean the surface of the appliance using a soft
cloth.
- Remove all soiling and contaminants in the
working area.
Troubleshooting
Problem Possible
causes
Repair
The appliance
is running
but does not
pump.
Suction area
4
is blocked
Clean the appli-
ance thoroughly
(see chapter enti-
tled “Cleaning”).
The appliance
is drawing in
air.
Immerse the
appliance in the
water at an angle
(see chapter en-
titled “Immersing
the Appliance in
the Water”).
Pressure hose
is buckled.
Make sure that
the pressure hose
is not buckled.
Discharge
head has been
exceeded.
Mind the dis-
charge head of
the pump.
The appliance
will not run.
There is no
supply volt-
age.
Check the supply
voltage.
Overheat
protection has
been activat-
ed.
Allow the appli-
ance to cool.
The float
switch
5
is
malfunctioning
Contact customer
service.
The motor is
malfunctioning
Contact customer
service.
The float
switch
5
does not oper-
ate
Set the float
switch
5
in a
higher position
(see chapter
entitled “Adjusting
the Float Switch”).
Make sure that
there is enough
water in the work-
ing area so that
the float switch
5
can operate.
Maintenance and Cleaning / Troubleshooting
Bekijk gratis de handleiding van Parkside PTPK 400 C1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PTPK 400 C1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5112 MB |
