Parkside PRTA 20-Li D3 handleiding
Handleiding
Je bekijkt pagina 20 van 96
18 GB/IE/NI
Cutting grass
I
o Cut the grass by swaying the product
sideways to the right and left.
o Cut slowly while the product is tilted
forwards by approx. 30°.
o Cut tall grass by a series of levels from top
to bottom.
Lawn edge trimming
m
CAUTION! Risk of injury!
u When working, make sure that the
protective cover
[] protects you from the
cutting device.
o To trim lawn edges, slowly move the
product along the lawn edges.
o Setup for edge trimming:
– Handle rod[6]: 180°
(see “Adjusting the handle rod”, Fig.F4)
– Cutting angle position: 5
(see “Adjusting the cutting angle”,
Fig.F3)
– Spacer bow[] in parking position
Switching the product on/off
m
WARNING! Risk of injury!
u After switching off the product, the
trimming assembly keeps revolving for
some time. Allow the trimming assembly
to come to a standstill. Keep hands and
feet away!
NOTE
u Maintain a firm stand and hold the
product well with both hands and at
some distance away from your body.
Before turning on the product, check that
it will not touch any objects.
u Remove grass cuttings regularly from the
spool cap
[] to make sure that cutting is
not impaired.
o Switching on: Use your thumb to actuate
the switch lock
[3], then press the on/off
switch
[2]. Release the switch lock.
o Switching off: Release the on/off switch.
There is no continuous operation mode.
Adjusting the product
Adjusting the auxiliary handle (Fig.F1)
o The auxiliary handle[5] can be set to
various positions. Adjust the handle so that
the spool cap[] is tilted slightly forward
as you work (see picture below “Cutting
grass”).
o Loosen the handle screw[] and move
the auxiliary handle to your favourite
position. Tighten the handle screw. The
latching steps integrated into the holder
prevent the handle from changing position
unintentionally.
Adjusting the height (Fig.F2)
NOTE
u The telescopic shaft[9] allows you to
adjust the product to your personal size.
o Loosen the threaded bush[8]. Adjust the
telescopic shaft to the correct length and
tighten the threaded bush.
Adjusting the cutting angle (Fig.F3)
NOTE
u Changing the cutting angle lets you trim
grass at places that a difficult to reach,
e.g. under benches or wall offsets.
Bekijk gratis de handleiding van Parkside PRTA 20-Li D3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PRTA 20-Li D3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9653 MB |
