Parkside PPFSA 40-Li C2 handleiding
Handleiding
Je bekijkt pagina 17 van 54
PPFSA 40-Li C2
■ 10
│
GB
│
IE
│
NI
v) When transporting or storing the machine,
always fit the cover on metal blades. Proper
handling of the machine will reduce the likeli-
hood of accidental contact with the blade.
w) Only use replacement cutters, lines, cutting
heads and blades specified by the manufac-
turer. Incorrect replacement parts may increase
the risk of breakage and injury.
x) When clearing jammed material or servicing
the machine, make sure the switch is off and the
battery pack is removed. Unexpected starting of
the machine while clearing jammed material or
servicing may result in serious personal injury.
Blade thrust causes and related
warnings
■ Blade thrust is a sudden sideways, forward or
backward motion of the machine, which may
occur when the blade jams or catches on an
object such as a sapling or a tree stump. It can
be violent enough to cause the machine and/or
operator to be propelled in any direction, and
possibly lose control of the machine.
■ Blade thrust and its related hazards can be
avoided by taking proper precautions as given
below.
a) Maintain a firm grip with both hands on the
machine and position your arms to resist
blade thrust. Position your body to the left side
of the machine. Blade thrust can increase the
risk of injury due to the machine moving unex-
pectedly. Blade thrust can be controlled by the
operator if proper precautions are taken.
b) If the blade binds, or when interrupting a cut
for any reason, switch the machine off and
hold the machine motionless in the material
until the blade comes to a complete stop.
While the blade is binding, never attempt to
remove the machine from the material or pull
the machine backward while the blade is in
motion, otherwise blade thrust may occur.
Investigate and take corrective actions to elimi-
nate the cause of blade binding.
c) Do not use blunt or damaged blades. Blunt or
damaged blades increase the risk of jamming or
catching on an object, resulting in blade thrust.
d) Always maintain good visibility of the materi-
al being cut. Blade thrust is more likely to occur
in areas where it is difficult to see the material
being cut.
e) If you are approached by another person
while operating the machine, switch the ma-
chine off. There is an increased risk of injury to
other persons being struck by the moving blade
in the event of blade thrust.
Safety instructions for battery chargers
■ This device may be used by chil-
dren aged 8 years and above
and by persons with limited physi-
cal, sensory or mental capacities
or lack of experience and knowl-
edge, provided that they are un-
der supervision or have been told
how to use the device safely and
are aware of the potential risks.
Do not allow children to play
with the device. Cleaning and
user maintenance tasks may not
be carried out by children unless
they are supervised.
■ To avoid potential risks, damaged
power cords should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable for indoor use only.
ATTENTION!
► This charger can only charge the following
batteries: PAP20A1/PAP20A2/
PAP20A3/PAP20B1/PAP20B3/
PAPS204A1/PAPS208A1.
Bekijk gratis de handleiding van Parkside PPFSA 40-Li C2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PPFSA 40-Li C2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6664 MB |
