Parkside PGS 500 C2 handleiding
Handleiding
Je bekijkt pagina 11 van 48
8
│
GB / CY
■ The tool spindle will continue to run after
the tool has been switched o. Do not
put the machine down until it has come
to a complete standstill.
■ Do not reach into the danger zone of the
machine while it is running.
■ Use only tools whose permissible speed
rating is at least as high as the highest
idling speed of the power tool.
■ Check grinding tools before use. The
grinding tool must be properly tted and
rotate freely. Perform a test run for at
least 30 seconds without any load. Do
not use damaged, non-circular or vibrat-
ing grinding tools.
■ Sanding metals creates ying sparks.
Make sure that no one is put at risk.
Because of the re hazard, make sure
there are no ammable materials in the
vicinity (ying spark area). Do not use a
dust extractor.
■ Always hold the tool so that sparks or
grinding dust y away from the body.
■ The clamping nut must be tightened
before the machine is put into operation.
■ Under the inuence of extreme external
electromagnetic interference, temporary
speed uctuations may occur.
■ The workpiece being machined must be
clamped if it is not held in place by its
own weight.
■ Never guide the workpiece onto the
grinding tool by hand.
■ Make sure that the grinding tool is tted
according to the manufacturer’s instruc-
tions.
■ The dimensions of the grinding tool must
be appropriate for the grinder.
■ Always work only with the intended
working surface of the accessory tool.
■ Firmly clamp the workpiece you are
working on. Never hold a small work-
piece in one hand and the straight grind-
er in the other while you are using it.
Always hold the straight grinder by the
designated handles.
■ Guide the straight grinder onto the work-
piece. Apply moderate pressure when
working and do not push the accessory
tool into the material.
Original accessories/attachments
■ Use only accessories and additional
equipment that are specied in the oper-
ating instructions (technical specications)
and are compatible with the appliance.
■ Approved accessory tools: Use only
corundum grinding tools with a shaft di-
ameter that corresponds to the installed
collet chuck. Observe the information in
the technical specication.
Use
Changing/inserting the tool/collet
chuck
♦ Press the spindle lock and hold it
down.
♦ Loosen the tensioning nut
from the
thread using the assembly wrench .
♦ Remove any tool that may be inserted.
♦ First, push the intended tool through the
tensioning nut
before inserting it into
the appropriate collet chuck
for the
tool shaft.
♦ Press the spindle lock
and hold it
down.
♦ Push the (6 mm) collet chuck into the
thread insert and screw the tensioning
nut
tight with the assembly wrench .
♦ To use the (3.2 mm) collet chuck ,
insert it into the pre-assembled (6 mm)
collet chuck .
IB_458746_PGS500C2_LB7_CY.indb 8IB_458746_PGS500C2_LB7_CY.indb 8 18.07.2024 13:37:5718.07.2024 13:37:57
Bekijk gratis de handleiding van Parkside PGS 500 C2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PGS 500 C2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5180 MB |
