Parkside PBH 1550 A1 handleiding
Handleiding
Je bekijkt pagina 13 van 19
13
NI
With the keyed chuck
13
, the
hammer drill can also be used for
drilling in iron, non-ferrous metals,
wood or plastic.
• Insert the keyed chuck
13
into the tool
holder (see chapter "Inserting the tool").
• Choose a drill bit suitable for the
machining and insert it into the keyed
chuck.
• Insert the keyed chuck
14
into one of the
holes on the sprocket.
• To tighten the chuck, turn the keyed chuck
clockwise.
• To loosen the chuck, turn the keyed chuck
anti-clockwise.
• Insert the drill bit properly at the desired
location.
• Press the On / Off switch
2
to start
drilling.
For drilling concrete
and stone:
Carbide tipped
masonry drill bit
For Metal HSS drill bit
For wood Twist drill bits for
wood
Selecting the appropriate drill bit
Chiselling
• Choose a chisel appropriate for the
material and insert it into the tool
as described in chapter 'Fitting and
changing tools'.
• Position the the chisel using the rotation
stop position if necessary as described in
"Function selection" .
• Insert the chisel properly at the desired
location.
• Press the On / Off switch
2
to start
chiselling.
6. Maintenance, cleaning,
storage and transport
WARNING!
Disconnect the mains plug before
any adjustment, maintenance or
repair.
Maintenance
The drill is practically maintenance-free.
Only use spare parts / accessories from the
manufacturer or authorised and qualified
workshops.
The following original spare parts are
available from the customer service
department of the manufacturer:
Parts description Item no.
Grease for tool inserts 643273
Carbon brushes 643015
Repairs should only be carried out by qualified
technicians or by an authorised service centre.
Qualified persons are those with appropriate
technical training and understand the safety
regulations.
Keep your tool bits always sharp. Sharpen them
always using a suitable tool as recommended
by the tool bit manufacturer.
Refilling the lubricating grease
(Fig. I)
In order to avoid ingression of dust and
leakage of grease, the pneumatic part of
the hammer drill is sealed. Refill grease after
50 operating hours or when the impact
power decreases.
Bekijk gratis de handleiding van Parkside PBH 1550 A1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | PBH 1550 A1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2661 MB |
