Parkside FCL-80115UK handleiding
Handleiding
Je bekijkt pagina 8 van 18
8 GB/IE/NI
manufacturer, their service representatives or an
equivalent professional!
Before use, verify the available mains voltage
matches the voltage required for operating the
light (220–240 V
~
, 50 Hz).
PREVENT FIRE AND INJURY
HAZARDS
CAUTION! RISK OF BURNS DUE TO HOT
SURFACES! Verify the light has been switched
off and has cooled down before touching it to
avoid burns. Light bulbs become very hot.
Do not cover the light with objects. Excessive
heat build-up can result in fire.
Never leave the light unattended whilst in
operation. Excessive heat can result in a fire.
The LED light is not dimmable.
Do not look directly into the light source (light
bulb, LED etc.). Do not look into the light source
(light bulb, LED etc.) with an optical instrument
(e.g. magnifier).
Any shattered protective covering
must be replaced.
Assembly
DANGER OF ELECTRIC
SHOCK! Only insert the mains plug into the mains
socket after it has been assembled. Otherwise there
is a risk of electric shock!
Note: You can use the light as a floor spotlight or
with the tripod
10
if necessary.
Assembling the spotlights
and handle piece on the
mounting bracket
First, unscrew the pre-installed fixing material
(screws
6
, clamping nuts
4
and the washers
pertaining to them) from the mounting bracket
5
(see fig. A, ensure that the washers are in the
correct order).
Screw both spotlights
2
with the clamping nut
4
and the washers to the mounting bracket
5
(see fig. B, ensure that the washers are in the
correct order).
Screw the handle piece
1
with the screws
6
and the washers to the mounting bracket
5
(see fig. C, ensure that the washers are in the
correct order).
Loosen the screw
13
on the reverse side of the
handle piece
1
and attach the mains cable
bracket
7
to the handle piece
1
(see fig. D).
Note: You can use the light in this form as a floor
spotlight.
Setting up the tripod
Loosen the clamping nut
11
by turning it counter-
clockwise (see fig. E).
Catch the tripod element where the legs are
connected at the same height as the clamping
nut
11
and press it downwards so that the legs
unfold.
If the tripod element cannot be pushed down
any further, and the legs have fully folded out,
re-tighten by turning the clamping nut
11
clock-
wise (see fig. F).
Setting the tripod height
(see fig. G)
Loosen the locking device
9
by turning it
counterclockwise.
Set the tripod
10
at the desired height by pull-
ing the rod elements upwards or pushing them
downwards.
Tighten the locking device
9
by turning it clock-
wise to fix the tripod
10
at the desired height.
Assembling the work light
on the tripod
Note: To assemble the work light on the tripod
10
you must firstly assemble the spotlights
2
and the
handle piece
1
on the mounting bracket
5
. Pro-
ceed as described in the chapter “Assembling the
spotlights and handle piece on the mounting bracket“.
Bekijk gratis de handleiding van Parkside FCL-80115UK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Parkside |
| Model | FCL-80115UK |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2465 MB |
