Panduit FHSCT handleiding
Handleiding
Je bekijkt pagina 6 van 11
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2018
FS119A
Page 6 of 11
5.9 For singlemode only: Place the puck in the center of the
distilled water on the film and pad. Keeping the puck flat
against the film and pad, apply even pressure and ONE TIME
ONLY drag the puck in a straight line 0.625" (16mm).
CAUTION: Do not exceed 0.625" (16mm) to avoid fiber
undercut
5.10 For singlemode only: Wipe the ferrule tip, pad and puck with
a dry wipe.
5.11 For singlemode only: Clean the ferrule with a distilled water
soaked wipe. Do not use alcohol to clean after using the
.05µm lapping film.
5.12 Place a dust cap over the ferrule assembly.
6. ASSEMBLING CONNECTOR AND BOOT
6.1 Push the boot forward onto the grooved area of the backbone
until it is against the flange.
7. ATTACHING DUPLEX CLIP
7.1 With a connector held as shown (latch on top, ferrule facing
away), insert the connector into one side of the duplex clip as
shown (clip held with the ‘A->B’ polarity marking upright and
facing forward). The upper tab of the clip should slide into the
pocket underneath the latch of the connector, and the lower
tab should slide under the connector housing and “snap”,
locking it into place.
7.2 Repeat this procedure for the other connector, completing the
duplexing step.
Note: When making cable assemblies, be sure to follow
the correct ‘A->B’ polarity cross-over between connectors.
0.625”
(16mm)
WET
5.10
.
0
5
µ
m
L
A
P
P
I
N
G
F
I
L
M
7.1
7.2
6.1
Boot against flange
Bekijk gratis de handleiding van Panduit FHSCT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Panduit |
| Model | FHSCT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1872 MB |
