Panduit FHSCT handleiding
Handleiding
Je bekijkt pagina 4 van 11
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2018
FS119A
3.2 Apply primer onto the bare fiber with the brush from the primer
bottle, and onto the first 1/8" (3.2 mm) of the buffer next to the
exposed fiber. Set fiber aside such that it will not collect debris
while completing the next three steps.
3.3 Insert the needle of the adhesive filled syringe into the rear of
the connector assembly until the needle bottoms against the
rear of the ferrule.
3.4 While pressing the needle firmly against the rear of the ferrule,
gently apply pressure on the plunger until a small bead of
adhesive forms on the front tip of the ferrule. Wait 3 seconds
before removing the needle from the ferrule assembly.
3.5 Carefully but quickly insert the bare fiber through the ferrule in
a smooth forward motion. The fiber is fully inserted when the
buffer bottoms against the rear of the ferrule. The adhesive will
begin to set within seconds.
Note: If adhesive oozes out the back of the assembly, you
have injected too much. It is critical to the function of the
connector that you wipe away all excess adhesive.
3.6 Allow one minute for the adhesive to harden before cleaving.
3.7 Clean the needle using a dry lint-free wipe. The needle should
be free of any excess adhesive before preparing the next
connector.
4. CLEAVING 900µm TIGHT-BUFFERED FIBER
4.1 Using a carbide scribe to cleave, gently make one small score
mark across the bare fiber just above the endface of the
ferrule. Pull the fiber away from the ferrule and discard it on
one of the sticky tabs provided. A short stub of fiber will
protrude from the tip of the ferrule when viewed through the
FLOUPEX10 Eye Loupe.
4.2 Clean the carbide blade and fingers using a dry lint-free wipe.
This will prevent contamination of the connector during polish-
ing and final assembly.
3.5
Page 4 of 11
1. SCORE
2. PULL FIBER
4.1
4.1
Adhesive Bead
3.4
Bekijk gratis de handleiding van Panduit FHSCT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Panduit |
| Model | FHSCT |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1872 MB |
