Optex TI-S handleiding
Handleiding
Je bekijkt pagina 33 van 148
2-7
1
2
Installation and Connections
Connecting the Sensor Head and Controller
2-3 Connecting the Sensor Head and
Controller
Connecting the sensor head cable
Connecting the sensor head cable to the controller.
①Align the connector notch on the sensor head cable with the controller-side groove.
② Insert the socket on the sensor head cable to the back of the controller-side plug.
③ Turn the tip of the socket on the sensor head cable to lock the connector.
2
31
Align these positions.
Connecting the general-purpose I/O and IO-Link cables
① Visually align the notches on the controller-
side plug with the protrusions on the cable-
side socket as shown in the figure on the
right, and then fit the socket into the plug.
② While pushing the socket on the cable, turn
the socket to align the notches and
protrusions.
③ After aligning these parts, push the socket in
until it clicks.
Ground wire connection
There is a functional ground terminal (M3 screw) on the bottom side of the controller.
Attach a terminal to the end of the ground wire and connect it to the functional ground terminal.
Recommended terminal: R1.25-3
Controller-side plug
I/O cable-side socket
Protrusions
Notches
Bekijk gratis de handleiding van Optex TI-S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Optex |
| Model | TI-S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 14359 MB |