Nord Modular G2 handleiding
Handleiding
Je bekijkt pagina 258 van 291
13. Module reference: MIDI group NORD MODULAR G2 V1.4x
Page 258
Note that if you want to send only the Program value on the Program input, set the knob to ‘0’.
Otherwise the Program number selected with the knob will be added as an offset to the input signal.
Note that as soon as the Program number changes, either by manually turning the knob or by inputting
a changing control signal, the module will output MIDI data even if the logic Send input is not activated.
A
PPLICATION
EXAMPLE
The PCSend module is perfect in combination with the
CtrlSend module for sending combined MIDI Bank
Select and Program Change messages:
Use the CtrlSend module to first transmit a Bank Select
message (MIDI CC#32) and then automatically force
the PCSend module to transmit a MIDI Program
Change message. By serial connecting the modules you
make sure the Bank Select message is sent prior to the Program Change message. The message order is
important for external synths to respond correctly. Of course, you can expand this serial connection by
adding more CtrlSend and PCSend modules.
N
OTE
S
END
The NoteSend module is used for sending out MIDI
Note On and Off messages on a selected MIDI channel.
The module can also send out Velocity values.
G
ATE
INPUT
A signal which goes from 0 units or below to anything above 0 units on the yellow Gate input will force
the module to send out the current Velocity and Note values on the selected MIDI channel. When the
Gate signal goes back to 0 units or below, the module sends a MIDI Note Off message on the selected
MIDI channel.
V
EL
Manually select the Velocity value you want the module to send with the knob. By patching a positive
unipolar control signal to the Vel control signal input, you can control the Velocity from an external
source. Range: 0-127 units in steps of 1 unit. See also "Common MIDI module parameters”.
Note that if you want to send only the Velocity values on the Vel input, set the knob to ‘0’. Otherwise
the value selected with the knob will be added as an offset to the input signal.
Note that the Velocity value is not sent out until a high logic signal is present on the Gate input.
N
OTE
Manually select the MIDI Note number you want the module to send with the knob. By patching a
positive unipolar control signal to the Note control signal input, you can control the Note number from
an external source. Range: C-1 to G9 in steps of 1 semitone.
Note! Always set the knob to ‘E4’ if you’re inputting regular bipolar Note data, e.g. from the Note
Sequencer module, otherwise the transmitted MIDI notes will be transposed.
Note that the Note number is not sent out until a high logic signal is present on the Gate input.
Bekijk gratis de handleiding van Nord Modular G2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Modular G2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 60689 MB |
