Nord Modular G2 handleiding
Handleiding
Je bekijkt pagina 257 van 291
NORD MODULAR G2 V1.4x 13. Module reference: MIDI group
Page 257
F
OR
ASSIGNING
AND
SENDING
A
MIDI CC#
FROM
A
K
NOB
ON
THE
SYNTH
PANEL
Just drag and drop a CtrlSend module to the Patch
window, select MIDI Ctrl number, MIDI Channel and
then assign the Value knob to an A
SSIGNABLE
K
NOB
on the synth panel. Turning the K
NOB
will then send MIDI CC data to the MIDI O
UT
of the synth. A
very simple solution to be able to control external MIDI gear from the G2 panel.
Tip! To make it easier to see in the A
SSIGNABLE
D
ISPLAY
which parameter you control, you can rename
the module from ‘CtrlSend1’ to e.g. ‘FilterCutoff’. Then, the A
SSIGNABLE
D
ISPLAY
will show
‘FilterCutoff’.
SENDING
A
SERIES
OF
DIFFERENT
MIDI C
ONTROLLERS
TO
EXTERNAL
MIDI
GEAR
Connect several CtrlSend modules in series where each
module sends a certain value on a certain MIDI CC# on
selectable MIDI channels. In this example, the first
module sends the value 64 for MIDI CC#7 on MIDI
channel 1. Right after this, the second module sends the
value 127 for MIDI CC#11 on MIDI channel 1. Finally,
the third module sends the value 50 for MIDI CC#21
on MIDI channel 3. This application is perfect for
sending initial MIDI information to external MIDI equipment in a predefined order.
F
OR
SENDING
CONTINUOUS
MIDI C
ONTROLLER
DATA
TO
P
ATCHES
IN
OTHER
S
LOTS
AND
/
OR
TO
EXTERNAL
MIDI
GEAR
Patch, for example, the Control signal output of a
CtrlSeq module and let it modulate the filter cutoff
frequency on a MIDI connected Nord Lead 3. Select the
correct MIDI CC# and correct MIDI channel and make
sure the Value knob is set to ‘0’. As the CtrlSeq runs. it
will continuously send different Control signal values to
the CtrlSend module, which in turn will output the
MIDI CC data on the MIDI Out. In these type of
applications you don’t have to use the logic Send input
of the CtrlSend module since the Value changes
continuously.
PCS
END
The PCSend module is used for sending out MIDI
Program Change messages on a selected MIDI channel.
S
END
INPUT
AND
OUTPUT
A signal which goes from 0 units or below to anything above 0 units on the yellow input will force the
module to send out the current Program number on the selected MIDI channel. Right after the reception
of the trig signal, the yellow output will transmit a logic pulse. This pulse can be used for triggering a
transmission of a MIDI Program Change message from another PCSend module, for example.
P
ROGRAM
Manually select the Program number you want the module to send with the knob. By patching a positive
unipolar control signal to the Program control signal input, you can control the Program number from
an external source. Range: 0-127 in steps of 1. See also "Common MIDI module parameters”.
Bekijk gratis de handleiding van Nord Modular G2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Modular G2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 60689 MB |
