Nord Modular G2 handleiding
Handleiding
Je bekijkt pagina 182 van 291
13. Module reference: Oscillator group NORD MODULAR G2 V1.4x
Page 182
N
OISE
F
ILTER
Here you can filter and affect the noise component of the Drum synth module.
F
REQ
: With the Freq knob you set the cutoff frequency of the noise. Range: 10 Hz to 15.8 kHz.
Res: With the Res knob you set the resonance amount around the cutoff frequency.
Swp: With the Sweep knob you set a sweep range for the cutoff frequency. The setting results in a sweep
from a high cutoff frequency down to the frequency you set with the Freq knob. Range: 0 to 5 octaves.
Dcy: The Decay knob sets the noise sweep and decay time. Range: 0.5 ms to 45 s.
HP/BP/LP: Click on the HP, BP or LP button to select filter mode: highpass, bandpass or lowpass.
B
END
Bend is a global function for the Master and Slave oscillators.
Amt: With the Amt knob you set the bend amount, i.e. the frequency range to bend through. The
bending always start from the higher frequency and sweeps down in frequency. Range: 0 to 5 octaves.
Dcy: With the Dcy knob you set the bend decay time. The bend time can be considered more as a bend
rate, since the actual decay time is determined by the Decay knobs of the two oscillators. Range: 0.5 to
45 s.
C
LICK
With the Click knob you can add a clicking sound to the attack of the sound.
N
OISE
With the Noise knob you set the noise level in the total mix.
P
RESET
Here you can choose between a number of factory presets by clicking on the up or down buttons. The
preset name is shown in the display box.
N
OISE
This module produces a noise signal, the noise timbre is
selectable from white (very bright) to colored (low
rumble).
W
HITE
/C
OLORED
Set the color of the noise with the control knob. Colored noise contains less high frequency energy than
white noise. See also "Common Oscillator parameters”.
M
ET
N
OISE
The metallic noise generator produces a noisy signal with
a bright metallic timbre. The timbre is created by a dense
cloud of short pulses with carefully detuned frequency
relations, creating clusters of high pitched partials in its audio spectrum. This type of noise is useful to
create the metallic sounds made by acoustic cymbals and hihats.
F
REQ
The Freq knob controls the basic pitch sensation of the metallic noise timbre.
C
OLOR
The Color knob acts like a highpass filter. When the Color knob is turned to the right it will pull the
timbre away into the highest parts of the audio range.
Bekijk gratis de handleiding van Nord Modular G2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Nord |
| Model | Modular G2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 60689 MB |
