Neewer QPRO-F handleiding
Handleiding
Je bekijkt pagina 12 van 20
※ Press the Back button to exit group highlighting page.
Trigger Settings
EN
12
Group Highlighting
Highlight multiple groups or one single group: in
multiple group setting, choose a group and press its
group letter twice to highlight this group and change
settings for this single group.
Set Flash Output
1. When multiple groups are set and in M mode:
1.1 Choose one group by pressing its group letter. Then,
rotate the dial to change flash output for this group
from Min. to 1/1 in increments of 0.1 or 0.3. Press the
< > button to confirm the output value and exit.
1.2 Press the <ALL> button to select all groups and make
their power output values editable, then rotate the
dial to change their output from Min. to 1/1 in
increments of 0.1 or 0.3. Press the <ALL> button
again to confirm the setting.
2. When one single group is highlighted and in M mode,
rotate the dial directly to change the group output
from Min. to 1/1 in increments of 0.1 or 0.3.
NOTE: "Min." refers to the minimum output level that
is available in M or Multi mode, 1/128(0.3) or
1/512(0.1) respectively based on the setting of
C.Fn-STEP. On most on-camera speedlite flashes,
the minimum output available is 1/128 or
1/128(0.3), not 1/512 or 1/512(0.1).
A
+3.0
TTL
Zoom
Zm/CH Gr MOD
69 mm
M
TTL
TTL
M
M
A
B
C
D
E
Zm/CH ALL MOD
1/128+0.3
1/128+0.3
1/128+0.3
+0.3
+0.3
Bekijk gratis de handleiding van Neewer QPRO-F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Neewer |
| Model | QPRO-F |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1629 MB |
