Neewer QPRO-F handleiding
Handleiding
Je bekijkt pagina 11 van 20
Mode Setting
1. Short press the <MODE> button to switch between
different modes.
2. When the trigger is set as 5 groups (A-E):
2.1 When multiple groups are set, you can switch on
Multi Flash for each group. Enter a group, select Multi,
choose "ON" or "--" to switch on/off.
2.2 For multiple group display, press the group selection
button or press the <MODE> button for single group
mode, the mode of group A B C can be switched
sequentially in TTL/M/- - mode and group D E only
in M/- - mode.
2.3 Long press the <MODE> button for 2 seconds until
the word "LOCKED" shows on the bottom part of
the display. The icon indicates that the trigger is
locked and no settings can be changed at this stage.
Long press the <MODE> button for 2 seconds to
unlock.
EN
11
Trigger Settings
Wireless ID Setting
In addition to pairing transmission channels, it is also
possible to match the wireless ID to avoid signal
interference. A TX unit and a RX unit have to be on the
same channel and set to the same wireless ID to trigger.
Press <MENU> button to enter C.Fn ID sub-menu. Rotate
the dial to select the <ID> menu. Then short press <SET>
button to make it editable, Finally, rotate the dial to
choose a wireless ID value and press button to confirm.
※ A master unit and a slave unit need to have matching
channels and ID to be triggered together.
CLEARSET
Ver:XX.X
LCD
SHOOT
DIST
ID
05
M
TTL
TTL
M
M
A
B
C
D
E
Zm/CH ALL MOD
1/128+0.3
1/128+0.3
1/128+0.3
+0.3
+0.3
ON
ON
ON
ON
LOCKED
MULTI
1/128
100
TIMES
199
Hz
A
B
C
D
E
Bekijk gratis de handleiding van Neewer QPRO-F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Neewer |
| Model | QPRO-F |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1629 MB |
