MSW -SPP48-110 handleiding
Handleiding
Je bekijkt pagina 23 van 255
EN
Disconnect from power source immediately if the pump malfunctions or the power cable insulation is
damaged.
Do not switch the pump on when standing in water or barefoot on a wet, electrically conductive surface.
Failure to observe the following guidelines may result in a device fault or sudden malfunction:
Install the pump in a well in a vertical position.
Before lowering the pump into a borewell, make sure the sludge has been cleaned out.
Do not use the pump to pump dirty water (e.g. contaminated with oil, particles, abrasive particulate
matter, etc.).
Do not use the pump for salt water, corrosive
substances, flammable liquids, etc.
Do not use with water which exceeds 35 °C.
If the pump is installed in a borewell which is too wide, it will lead to insufficient cooling and the device
will overheat. In this case, a cooling jacket should be installed.
Do not start the pump before it is submerged in water. "Dry" operation results in permanent damage to
the pump. The pump should be fully submerged, and the water surface should be at least 2 m above the
water discharge holes.
Attach the power cable to the delivery pipe (using cable ties for example) at least every 2 m to avoid the
cable braking under its own weight.
Use a non-return valve to protect the pump against returning water impact.
Before lowering the pump into a new borewell ensure sludge, silt and sand have been thoroughly cleaned
out.
Using the pump for pumping water with a high mineral content is not recommended. Water with a high
mineral content may result in the appearance of deposits on the pump housing, preventing correct
cooling of the motor which in turn might lead to overheating and damage the motor.
Do not use the pump if the ambient temperature is below zero. Frozen water will damage the device and
the water delivery system to the surface.
Do not obstruct the water outlet when in use.
Use a rope (standard nylon preferably) attached to the pump handles to lift, carry and lower the pump
into a borewell.
The product should be used under the supervision of a person with appropriate knowledge in terms of its
use and operation.
Bekijk gratis de handleiding van MSW -SPP48-110, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -SPP48-110 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 34027 MB |
