MSW -CONCRETE-VPO750 handleiding
Handleiding
Je bekijkt pagina 25 van 264
EN
LOSS OF TENSION
• Core overheating
• Core overheating as a result
of blade spinning on arbor
• Core overheating from
rubbing the material being
cut
• Unequal pressure at blade
clamping collars / flanges
• Blade is too hard for the
material being cut
• Make certain blade RPM is correct
• Check water flow, distribution and
lines
• Tighten the blade shaft nut. Make
certain the drive pin is functioning
• Properly align the saw to square cut
• Collars / flanges must be identical in
diameter and the recommended size
• Use a softer bond / matrix to reduce
stress
BLADE WOBBLES
• Blade is on a damaged or
worn saw
• Worn collar
• Blade runs at an incorrect
speed
• Collar / flange diameters are
not identical
• Blade is bent as a result of
dropping or twisting
• Check collars / flanges to make sure
they are clean, flat and of correct
diameter
• Set engine at proper RPM
• Use proper size blade collars / flanges
• DO NOT use bent blade. Contact blade
manufacturer
ARBOR HOLE OUT -
OF- ROUND
•
Blade is too hard for material
being cut
• Blade has become dull
• Blade does not cut material it
was specified for
•
Select proper blade for material being
cut
• Sharpen by cutting on softer abrasive
material to expose diamonds. If
continually sharpening, the blade is too
hard for the material being cut
• Break – in on the material to be cut. If
is dose not dress itself, sharpen as you
would a dull blade
UNDERCUTTING
THE CORE
• Abrasive wearing of the core
faster than the segments
• Use water to flush out fines generated
during cutting
• Use wear- resistant cores
Bekijk gratis de handleiding van MSW -CONCRETE-VPO750, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -CONCRETE-VPO750 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 46743 MB |
