MSW -CONCRETE-VPO750 handleiding
Handleiding
Je bekijkt pagina 21 van 264
EN
7) Reconnect the spark plug or (with switch “off”) plug in the electric supply cord.
3.5. TYPES OF CUTTING
Cut speed depends entirely on using the correct blade for the material to be cut. Wet or dry,
diamond blades of various specifications are available for cutting concrete or asphalt.
3.6. BEFORE STARTING
1) Use correct blade for cutting conditions.
2) Ensure arbores and flanges are clean undamaged.
3) Mount blade and tighten securely using wrench.
4) When wet cutting, check water jets for adequate flow.
5) Align pointer with cutter blade.
Caution – Set unit up in an open area. Avoid close proximity to structures or other equipment.
Failure to do so may cause inadvertent injury to operator or other persons in the area.
Cold start – open the fuel valve under the gas tank all the way. Position the engine stop switch,
located on the engine, to run. Open the throttle approximately halfway and apply the choke. Pull the
starter rope sharply. When the engine starts, open the choke and adjust the throttle as necessary to
keep it running. Allow the engine to warm up for a few minutes before placing it under the load. If
the engine doesn’t start after (3) pulls, open choke slightly to prevent flooding. Always operate the
engine at full throttle when under load.
Hot Start – Open the valve under the gas tank all the way if it has been shut off. Open the throttle
approximately halfway. Do not apply the choke. Pull the starter rope sharply until the engine starts.
When the engine starts, adjust the throttle. Always operate the engine at full throttle when under
load.
NOTE: These stating instructions are general guidelines only. Since many engine options are
available, consult the Engine Manual included with this unit for specific instructions.
Caution-Gasoline Engines – To improve the engine service life, allow the engine to idle without load
for (2) to (5) minutes before shutting it down. When the idling period is up, use the stop switch
located on the engine and turn it to stop. Close the fuel valve under the gas tank. Engine flooding can
occur if the valve is left open during transport.
3.7. TO START CUTTING
1) Start engine and let engine warm up. All cutting is done at full throttle.
2) Align blade and cutter with cut. If wet cutting, open water valve and turn water safety switch
on.
3) Lower blade into cut slowly.
4) Cut as fast as blade will allow. If blade climbs out of cut, reduce forward speed or depth of
cut.
5) Use only enough side pressure on cutter handles to follow cutting line.
3.8. CUTTING
Lower the blade into concrete to required depth by turning the tilt crank counterclockwise. Ease the
saw slowly forward. Slow forward pressure if the saw begins to stall.
Bekijk gratis de handleiding van MSW -CONCRETE-VPO750, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -CONCRETE-VPO750 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 46743 MB |
