MSW -CONCRETE-VPO750 handleiding
Handleiding
Je bekijkt pagina 20 van 264
EN
III. OPERATION
3.1. INTRODUCTION
Congratulations on your purchase of our Cutter! You’ve made an excellent choice! Our floor cutter
has been specifically designed as the ideal machine for the professional contractor who is engaged in
concrete and asphalt flat sawing.
The machines used for the primary purpose of “flat” sawing. This type of sawing is described as “flat”
because the pavement is cut somewhere close to a horizontal plane. It is the most common type of
diamond blade cutting.
Concrete cutter in the industry is available in a variety of types, size and styles, they range from
manual for self-propelled in horsepower form 7-72hp. It is possible to cut both concrete (green or
cured, with or without rebar) or asphalt with a concrete cutter. Our MF12 utilized for jobs requiring
precision cutting including floors, pavements, walkways, ramps and other flat sawing applications.
You will find a cutter to fit a wide variety of job applications.
Upon receipt of your machine, CAREFULLY CHECK FOR ANY FREGHT DAMAGE. Any damage should be
immediately reported to the carrier and a claim registered.
3.2. OPERATING PRINCIPLE
The following instructions were compiled to provide you information on how to obtain long and
trouble-free use of the unit. Periodic maintenance of this unit is essential. Read the manual in its
entirety and follow the instructions carefully. Failure to do so may injure yourself or a bystander.
3.3. DELIVERY CHECKS
• Immediately upon taking delivery of your new equipment and before putting it into service:
Read the handbook completely-it could save a great of unnecessary expense.
• Read the engine manual supplied.
• Check the general condition of the equipment and if there was any damage during delivery.
• Check engine oil level.
• Check fuel levels.
• NOTE: Recommend lubricants are detailed in the CARE AND MAINTENANCE section.
3.4. INSTALLING BLADE
1) Be certain that the spark plug is disconnected or saw in unplugged.
2) Remove the blade shaft nut and take off outside blade shaft flange.
3) Clean off any foreign particles on the clamping surfaces of flanges and on the mounting
surface of the blade.
4) Place the blade on the blade shaft, lining up the offset drive pin in the blade with drive pin in
the mounting collar (if the pin system is available on the machine). If your blade has a
directional rotational arrow, position arrow for down cut (diamond tail trailing for down cut).
5) Replace the outside blade shaft flange on the blade shaft. Drive pin on the inside collar must
project through the drive in the blade and into the outside collar (if the pin system is
available on the machine).
6) Tighten the blade shaft nut securely against star washer and outside flange, using wrench
supplied.
Bekijk gratis de handleiding van MSW -CONCRETE-VPO750, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -CONCRETE-VPO750 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 46743 MB |
