MSW -CONCRETE-VPO750 handleiding
Handleiding
Je bekijkt pagina 22 van 264
EN
Note: For deeper cuts (4 inches/102mm or more), several cuts should be made in incremental steps
of 1-1/2 inch (38mm) to 2 inches (51mm) until the desired depth is reached.
Push the saw steadily forward using the front pointer as a guide. Exert enough forward pressure so
that the engine / motor begins to labour but does not slow down. If the saw begins to stall, retard
forward movement until full RPM is restored to the blade. If saw stalls, raise the blade out of the cut
before restarting. Avoid excessive side pressure or twisting of the blade in cut.
3.9. BELTS & PULLEYS
NEVER MAKE ADJUSTMENTS TO V-BELTS AND PULLEYS WHILE ENGINE IS RUNNING
1) The best tension for a v-belt drive is the lowest tension at which the belts will not slip under
full load.
2) Take up tension until the belts are snug in the grooves. Run the drive for about five (5)
minutes to “seat” the belts. The belts. The impose the peak load. If the belts slip, tighten
them until they no longer slip at peak load. Most new belts will need additional tensioning
after seating.
3) Remember, too much tension shortens belt and bearing life.
4) Check the belt tension frequently during the first day of operation. Check the belt tension
periodically thereafter and make any necessary adjustments.
5) The two most common causes of sheave misalignment are:
a. The engine drive shaft and the blade shaft are not parallel.
b. The pulleys are not located properly on the shafts.
6) To check alignment, use a steel straight edge. See Figure 1.
7) Line up the straight edge along the outside face of both pulleys shown in the drawing. All
pulleys have (2) set screws in the bottom of their grooves. Set screws require thread locking
lock title.
Bekijk gratis de handleiding van MSW -CONCRETE-VPO750, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MSW |
| Model | -CONCRETE-VPO750 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 46743 MB |
