Midea MKE15H2ADW handleiding
Handleiding
Je bekijkt pagina 12 van 84
09
Boil Water to Set Temperature
1. Press the lid opening button to open the lid.
2. Pour the required water into the pot ( the amount of water
between the minimum and maximum ).
3. Cover the lid and plug it into an electrical outlet.
4. Press to select the temperature, and hold the button
for more than 2s, the light will light up, then Press
within 3 seconds to start the work.
5. After reaching the set temperature, the buzzer will beep 3 times
and automatically enter the keep-warm state, and the
temperature will be maintained at the set temperature.
6. After the water boiling ends, kettle will enter the standby mode.
Tip:
· Eexcept for 100°C, the set temperature can be adjusted by short pressing the
button again during operation of other temperature levels. The set temperature can be
cycled among 45, 60, 70, 85, 90, 95 and 100.
· Keep warm at 45°C for 8 hours (± 20 minutes), 60°C for 4 hours (± 10 minutes) 70°C or
85°C for 2 hours (± 5 minutes), 90°C or 95°C for 1 hour (± 5 minutes).
· The corresponding green setting temperature function indicator is always on.
· In the process of heat preservation, the real-time temperature is displayed before the
real-time temperature drops to the holding temperature, and the set temperature is
displayed after the temperature drops to the set temperature, and the real-time
temperature is displayed when the water temperature exceeds or is lower than the set
temperature by 5 degrees.
· In the process of heat preservation, the heat preservation temperature can be adjusted
by the heat preservation button;
· The heating system works according to the insulation preset procedure.
· When the holding time is over, it will shutdown.
· In the power on state, when the fault occurs, the alarm (buzzer calls 1o times) will enter
the fault mode. At the same time, the nixie tube will display the fault code, all function
indicator lights will go out, and all buttons will not respond.
· In the shutdown state, when the fault occurs, no fault code is displayed, no alarm
(buzzer does not sound), and all displays remain o.
· Short press any key and click to enter failure mode.
EN
Bekijk gratis de handleiding van Midea MKE15H2ADW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Midea |
| Model | MKE15H2ADW |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4680 MB |
