MGL Avionics Vega TP-3 handleiding
Handleiding
Je bekijkt pagina 14 van 28
Vega TP-3 Operating Manual Page 14
4.3 COMM Setup (Communication Setup)
Serial Out:
Select “ON” to enable the RS232 serial output.
Unit Address:
Enter the unit address.
Baud Rate:
Select the desired baud rate of the serial output.
The transmission format is set to 8 data bits, No parity, 1 stop bit. The baud rate can be changed in the Communication
Menu.
4.3.1 Protocol Format
STX, Address, Message type, Length, Data payload, Checksum, ETX
STX: Start of text (0x02)
Address: unsigned char (8bit), Unit address (range 0-255)
Message Type: unsigned char (8bit), Specifies the message type
Length: unsigned char (8bit), Length of the data payload (does not include the STX, Address, message type, checksum or
ETX)
Data payload: Data
Checksum: unsigned char (8bit), XOR of all bytes starting from the unit address to the end of the data payload. The
checksum is seeded with 0xa5. (does not include the STX or ETX)
ETX: End of text (0x03)
Bekijk gratis de handleiding van MGL Avionics Vega TP-3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MGL Avionics |
| Model | Vega TP-3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4659 MB |
