Metra 108-FD2B handleiding
Handleiding
Je bekijkt pagina 7 van 12
REV.
12/9/22
INST108-FD2B
7
PROGRAMMING FINAL ASSEMBLY
1. Secure the completed radio assembly to the dash using the factory hardware.
2. Snap the radio trim panel with touchscreen display over the radio, then reassemble the dash
in reverse order of disassembly to complete the installation.
1. Refer to step 2 from the Installation section.
2. Press the push-to-start button to start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type.
b. Wait until the radio comes on, and the touchscreen display shows SWC Configured*.
This process may take up to 3 minutes..
Note: If the touchscreen display does not load up, or the radio doesn’t come on within
3 minutes, and/or the touchscreen display does not show SWC Configured*, check all
connections, then reset the interface and try again. Refer to the Troubleshooting section.
* For models with steering wheel controls.
4.
Cycle the key off. If the driver’s door is closed, open and close the door. Cycle the key back on.
5.
Test all functions of the installation for proper operation, before reassembling the dash.
SYNC:
If the vehicle is equipped with SYNC, the 108-FD2B can retain this feature.
1. Change the source of the radio to AUX.
2. Press the Info button on the touchscreen display to enter the SYNC menu.
1. Press the climate icon to get back to the main menu.
EXTRA FEATURES
Bekijk gratis de handleiding van Metra 108-FD2B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 108-FD2B |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1711 MB |
