Metra 108-FD2B handleiding
Handleiding
Je bekijkt pagina 6 van 12
386.257.1187
|
MetraOnline.com
6
CONNECTIONS (CONT)
3.5mm jack - steering wheel control retention:
The 3.5mm jack is to be used to retain audio controls on the steering wheel control.
• Connect the 3.5mm jack into the wired remote input from the aftermarket radio.
Refer to the manual provided with the radio if in doubt as to where the 3.5mm jack goes to.
From the backup camera harness to the aftermarket radio:
There are two different methods for connecting the factory backup camera.
If retaining the camera to the aftermarket radio is desired:
• Connect the Yellow RCA jack to the rear view camera input from the aftermarket radio.
If retaining the camera to the touchscreen display is desired:
• Connect the Yellow RCA jack, to the Yellow RCA jack from the 4-pin harness with yellow
RCA jacks labeled “Rearview camera”.
Note: If this method is chosen, the backup camera option must be enabled in the
Configuration Settings.
• Disregard the Yellow RCA jack from the 4-pin harness with yellow RCA jacks labeled
“AUX video”, it will not be used in this application.
I N STAL L ATI O N
It is highly advisable to read the following steps beforehand, to ensure a clear understanding of what
is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
1.
Connect the
16-pin harness with stripped leads
into port “B” in the touchscreen display
.
2. Connect the main harness to the wiring harnesses in the vehicle. These harnesses are the
ones removed in step 4 of dash disassembly. Then insert the main harness into port “A” in
the touchscreen display. But do not install this harness until exactly before step 1 from the
Programming
section. This is a timed process.
3.
Connect the 4-pin harness with yellow RCA jacks into port “C” in the touchscreen display.
4.
Connect the hazard harness into port “D” in the touchscreen display and then to the wiring
harness in the vehicle. This is the harness removed in step 3 of dash disassembly.
5. Disregard port “E”, it will not be used in this application.
6. Port “F” is an update port for future firmware upgrades.
A
B
C
E
F
D
Note: DO NOT CONNECT!
Bekijk gratis de handleiding van Metra 108-FD2B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 108-FD2B |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1711 MB |
