Megger EVX100 handleiding
Handleiding
Je bekijkt pagina 12 van 24
www.megger.com
EVX100
12
Testing the EV charger
6. The EVX100 will now send a status
sequence of A, B and C to the charger.
This is shown at the bottom of the
MFT-X1 display.
7. The charger should lock the connector
in place and the MFT-X1 will display the
single or 3 phase voltages of the charger
output.
EV voltage status
8. The EVX100 LED will now flash GREEN, YELLOW or RED once every 10 seconds
depending on charge status.
NOTE : Many chargers have a startup delay of up to 5 minutes. If this is the case them
most of these chargers have a “Start charging now” option on the EV charger. Pressing
this button should switch the charger into charging mode (State C).
5.2 MFT-X1 connection errors
After switching on the MFT-X1 the EVX100 LED continues to rapidly flash Yellow for more than
30seconds, the EVX has not established connection to the MFT.
In this situation:
1. Switch off the MFT-X1.
2. Remove the EVX100 from the MFT and re-insert to the MFT.
3. Switch the MFT-X1 to Volts and wait for the LED again.
4. If the MFT still does not make connection to the EVX100 contact Megger technical
support: uksupport@megger.com or +44 (0) 1304 502 102
5.3 Manual battery status check on the EVX100
The charger status can be manually checked at any time by holding down the power button
on the top of on the adaptor. The LED battery status light on the top of the EVX will indicate
charge status. See 4.1 Battery status and charging on page 10.
Bekijk gratis de handleiding van Megger EVX100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Megger |
| Model | EVX100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3687 MB |