MDT SCN-BWM55T.G2 handleiding
Handleiding
Je bekijkt pagina 58 van 67
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt-group.com
58 / 67
Technical Manual
Motion Detector/Automatic Switch 55/63 [SCN-BWM55/63(T)(06).x2]
State 07/2025 - Version 1.4
Sending functions
The “Send brightness on change of”parameterspecieswhetherand,onwhatpercentagechange,the
current measured value is sent. If the setting is “not active”, the sensor will not send a value, regardless of
the change.
The “Send measured value cyclically” parameter can be used to specify whether and at what interval the
current measured value is sent cyclically.
Note: The sending functions can be activated or deactivated independently of each other. If both
parameters are deactivated, no value will be sent.
Object “Set switch-on threshold for light channels”
This object can be used to send a brightness switch-on threshold to the device via the bus. This value
replacesthe“Switch-onlevelforDay/Night”speciedunder“Generalsettings”fortheactiveDay/Night
mode. After a bus voltage failure, the device will resume operation with the preset values. The object is
shown permanently.
The following table shows the associated communication objects:
No. Name/Object function Length Usage
97 Brightness – Send measured value 2 Byte Sends the brightness sensor measurement
value
98 Brightness – Set switch-on threshold
for light channels
2 Byte Receives a value for the global switch-on
threshold light channels.
Table 71: Communication objects – Brightness
Bekijk gratis de handleiding van MDT SCN-BWM55T.G2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MDT |
| Model | SCN-BWM55T.G2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10289 MB |
