McGregor GCS4002 handleiding
Handleiding
Je bekijkt pagina 26 van 32
After Sales Support 0345 605 2065
V1.7 03/23
Maintenance
Maintenance
8) Fit the guide bar cover onto the bar pad, make sure the hole of the cover is directly inserted into the guide
bolt. Hold the tool-free lock knob and turning it clockwise to tighten the guide bar cover. Check to see if the cover
is pressed tight and smoothly with the guide bar and saw chain body. (See Fig. K5, K6)
K2
K3
K4
K5
K6
a
K1
Loosen
Tighten
Indicates
direction of
chain
9) Check the chain tension: The correct chain tension is reached when the chain can be raised approx. 3-5 mm
from the guide bar in the centre (using a small amount of force). This should be done by using one hand to raise
the chain against the weight of the machine. Do not tension the chain too much. (See Fig. K7)
Bar
3-5mm
K7
4. MAINTENANCE AND STORAGE OF CHAIN SAW
1) Remove the plug from the socket
When not in use
Before moving from one place to another
Before servicing
Before changing accessories or attachments, such as saw chain and guard
2) Inspect chain saw before and after each use. Check saw closely if guard or other part has been damaged.
Check for any damage that may aect operator safety or operation of saw. Check for alignment or binding of
moving parts. Check for broken or damaged parts. Do not use chain saw if damage aects safety or operation.
Have damage repaired by authorized service center.
3) Maintain chain saw with care.
Never expose saw to rain or direct moisture.
Keep chain sharp, clean, and lubricated for better and safer performance.
Keep handles dry, clean, and free of oil and grease.
Keep all screws and nuts tight.
4) When servicing, use only identical replacement parts.
5)When not in use, always store chain saw
in a high or locked place, out of children’s reach
in a dry place
with guide bar cover in place
5. BAR MAINTENANCE
To maximize bar life, the following bar maintenance is recommended.
The bar rails that carry the chain should be cleaned before storing the tool or if the bar or chain appear to be dirty.
The rails should be cleaned every time the chain is removed.
26 of 31
Bekijk gratis de handleiding van McGregor GCS4002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | McGregor |
| Model | GCS4002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3478 MB |
