McGregor GCS4002 handleiding
Handleiding
Je bekijkt pagina 27 van 32
After Sales Support 0345 605 2065
V1.7 03/23
Maintenance
Maintenance
TO CLEAN THE BAR RAILS:
1) Remove chain cover and bar and chain.
2) Using a wire brush, screwdriver or similar tool, clear the residue from the inner groove of the bar. (See Fig.
L1)
3) Make sure to clean oil passages thoroughly
CONDITIONS WHICH REQUIRE CHAIN AND GUIDE BAR MAINTENANCE:
(See Fig. L2)
Saw cuts to one side or at an angle.
Saw has to be forced through the cut.
Inadequate supply of oil to the bar and chain.
Check the condition of the Guide Bar each time the chain is sharpened. A worn Guide Bar will damage the
chain and make cutting dicult.
After each use, remove the plug from the socket, clean all sawdust from the guide bar and drive sprocket
hole.
When rail top is uneven, use a at le to restore square edges and sides.
Replace the guide bar when the groove is worn, the guide bar is bent or cracked, or when excess heating or
burring of the rails occurs. If replacement is necessary, use only the guide bar specied for your saw in the
spare parts list.
L1
L2
File Rail Edges
and Sides
Square
Worn Groove Correct Groove
6. LUBRICATE DRIVE SPROCKET
WARNING: Remove the plug from the socket before performing any service or maintenance
on this tool.
WARNING: Wear heavy duty gloves when performing any maintenance or service to this tool.
NOTE: It is not necessary to remove the chain or bar when lubricating the drive sprocket.
1) Clean the bar and drive sprocket
2) Using a grease gun, insert the tip of the gun into the lubrication hole (b) and inject grease until it appears
at the outside edge of the drive sprocket tip. (See Fig. M)
3) To rotate the drive sprocket pull the chain by hand until the ungreased side of the drive sprocket is in line
with the grease hole. Repeat the lubrication procedure.
M
b
27 of 31
Bekijk gratis de handleiding van McGregor GCS4002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | McGregor |
| Model | GCS4002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3478 MB |
