McGregor GCS4002 handleiding
Handleiding
Je bekijkt pagina 24 van 32
After Sales Support 0345 605 2065
V1.7 03/23
Maintenance
Maintenance
1. KICKBACK SAFETY DEVICES ON THIS SAW
This saw has a low-kickback chain and reduced kickback guide bar. Both items reduce the chance of
kickback. However, kickback can still occur with this saw.
The following steps will reduce the risk of kickback.
Use both hands to grip saw while saw is running. Use rm grip. Thumbs and ngers must wrap around saw
handles.
Keep all safety items in place on saw. Make sure they work properly.
Do not overreach or cut above shoulder height.
Keep solid footing and balance at all times.
Stand slightly to the left side of saw. This keeps your body from being in direct line with chain.
Do not let guide bar nose touch anything when chain is moving.
Never try cutting through two logs at same time. Only cut one log at a time.
Do not bury the guide bar nose or try plunge cut (boring into wood using guide bar nose).
Watch for shifting of wood or other forces that may pinch chain.
Use extreme caution when reentering a previous cut.
Use only the low-kickback chain and guide bar that were supplied with this chain saw or recommended
replacements.
Never use a dull or loose chain. Keep chain sharp with proper tension.
2. HOW TO USE SAW SAFELY (SEE FIG. J)
1) Use the chain saw only with secure footing.
2) Hold the chain saw at the right-hand side of your body (See Fig. J1).
3) The chain must be running at full speed before it makes contact with the wood.
4) Do not operate the chain saw with arms fully extended, attempt to saw areas which are dicult to reach, or
stand on a ladder while sawing (See Fig. J2).
Never use the chain saw above shoulder height.
J1
J2
3. REPLACING THE CHAIN AND GUIDE BAR (SEE FIG. K)
WARNING: Use only chains and guide bars designed for this chain saw.
WARNING: Ensure the product is disconnected from the mains power supply before attempting
any maintenance.
WARNING: Cutting edges on chain are sharp. Use protective gloves when handling chain.
The chain needs replacing when:
The sawdust produced when sawing damp wood looks like wood our.
The chain penetrates the wood only under great pressure.
The cutting edge is visibly damaged.
The saw is pulled to the left or right when sawing. This is caused by uneven sharpening of the chain.
Keep chain sharp. Your saw will cut faster and more safely. A dull chain will cause undue drive sprocket,
guide bar, chain, and motor wear. If you must force chain into wood and cutting creates only sawdust with few
large chips, chain is dull.
24 of 31
Bekijk gratis de handleiding van McGregor GCS4002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | McGregor |
| Model | GCS4002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3478 MB |
