McGregor GCS4002 handleiding
Handleiding
Je bekijkt pagina 23 van 32
After Sales Support 0345 605 2065
V1.7 03/23
Operation
Operating instructions
H
I
7
6. CUTTING
WARNING:Check oil level gauge prior to starting and regularly during operation. Rell chain oil
(not supplied) when oil level is low.
WARNING:Check the chain tension approx. every 10 minutes during operation.
WARNING: Always wear safety goggles, ear protection, protective gloves and heavy-duty work
clothes during operation.
WARNING: Check the automatic lubrication as described above.
1) To start the device, connect the power plug to the mains socket.
2) Make sure section of log to be cut is not laying on the ground. This will keep the chain from touching the ground
as it cuts through the log. Touching the ground while the Chain is moving is dangerous and will dull the Chain.
3) Use both hands to grip saw. Always use left hand to grip Front Handle and right hand to grip Rear Handle.
Use a rm grip. Thumbs and ngers must wrap around saw handles. (See Fig. I)
4) Make sure your footing is rm. Keep feet-shoulder width apart. Distribute your weight evenly on both feet.
5) When ready to make a cut, push the lock-o button completely in with the right thumb and squeeze the
trigger. This will turn saw on. Releasing the trigger will turn the saw o. Make sure the saw is running at full
speed before starting a cut.
6) When starting a cut, slowly place moving chain against the wood. The wood should be as close to the saw
body as possible. Hold saw rmly in place to avoid possible bouncing or skating (sideways movement) of saw.
7) Guide the saw using light pressure and do not put excessive force on the saw, letting the saw do its
work. The motor will overload and can burn out. It will do the job better and safer at the rate for which it was
intended.
8) Remove the saw from a cut with the saw running at full speed. Stop the saw by releasing the On/o Switch.
Make sure the chain has stopped before setting the saw down.
9) Keep practicing on scrap logs in a secure working area until you are comfortable, using a uid motion and a
steady cutting rate.
10) After working with the chain saw, you should always: Clean the saw chain and guide bar and replace the
guide bar cover.
H
I
7
23 of 31
Bekijk gratis de handleiding van McGregor GCS4002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | McGregor |
| Model | GCS4002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3478 MB |
