McGregor GCS4002 handleiding
Handleiding
Je bekijkt pagina 22 van 32
After Sales Support 0345 605 2065
V1.7 03/23
Operation
Operating instructions
E
1
2
3. CHECKING THE CHAIN BRAKE (SEE FIG. F)
The chain brake must be checked before every use of the saw!
Start the tool as described above (have a secure footing, place the chain saw on the ground so that the saw
chain and guide bar are not near anything).
Hold the front handle rmly, with your other hand on the rear handle.
Let the tool run at medium speed and push the hand guard in the direction of the arrow A using the back of your
hand, until the chain brake engages. The chain should now stop immediately.
Pull the hand guard backwards until you feel it catch. The brake is now disengaged.
WARNING:Always engage the chain brake when not in use.
CAUTION: If the saw chain does not stop immediately in this test, turn o the tool immediately. Do NOT use the
chain saw in this condition! contact customer service agent or approved service agent.
4. CHECKING THE AUTOMATIC LUBRICATION (SEE FIG. G)
Proper functioning of the automatic oiler can be checked by running the chain saw and pointing the tip of the
guide bar towards a piece of cardboard or paper on the ground. After running for 50-60 seconds, if an increasing
oil pattern develops on the cardboard, the automatic oiler is operating ne. If there is no oil pattern, despite a full
oil reservoir, contact customer service agent or approved service agent.
WARNING: Do not touch the ground with the saw chain. Ensure safety clearance of 30cm.
F
G
A
5. BUMPER SPIKE
The bumper spike can be used as a lever during sawing by repositioning at a lower point below the cut when
sawing thick branches or trunks. (See Fig. H)
To do this, pull the chain saw back a little after the cut to release the bumper spike and set it lower again.
Do not remove the saw from the cut.
When sawing, do not press the chain saw with force, but let it work by applying a slight lever pressure to the front
via the bumper spike and sawing further into the existing cut.
The optimum sawing result is achieved if the chain speed during sawing does not drop due to overload.
22 of 31
Bekijk gratis de handleiding van McGregor GCS4002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | McGregor |
| Model | GCS4002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3478 MB |
