Master-Bilt QS2 handleiding

Handleiding

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104/ 104

Afdrukken

Je bekijkt pagina 21 van 104

21

8/22 Rev. R 132617 ©2022 Refrigerated Solutions Group. All rights reserved.

WALK-IN INSTALLATION

Figure 5

After the first sealer (screed) section is positioned over the sealer guide and over the highest point, it must be

LEVELED PERFECTLY not only over its length but, across its width, as well. To achieve this, shimming material

will probably be required. Vinyl floor tile cut in strips 7/8” wide by 6” long make ideal shimming strips that can be

placed beneath the sealer, wherever necessary, to achieve levelness.

IMPORTANT: EVERY SECTION OF SEALER (SCREED) MUST BE SUPPORTED AT LEAST EVERY 24” BY

EITHER THE BUILDING FLOOR OR BY SHIMMING. Avoid using shimming strips less than 6” long whenever

possible (see Figure 4).

Assuming that the first sealer (screed) section has been perfectly leveled, refer to the sealer diagram and select an

adjoining sealer section and level it perfectly in both directions, shimming wherever necessary. NOTE: Sealer

(screed) sections 8” high or more employ section latches for end-to-end locking. CAREFULLY flush the upper edges

and the inner or outer surfaces of adjoining sealer sections while locking them together (Figure 5). Continue leveling

the remainder of the sealer sections until the entire assembly is in position.

When the entire sealer assembly is leveled, apply NSF approved sealant to achieve a vapor seal between the

bottom edge of the sealer and the building floor. This sealant is provided and is packed in the hardware box. The

sealant must be applied to the inner and outer surfaces of the sealer (screed) assembly. Make certain that the

sealant produces a complete, air-tight seal, without gaps, and that special care is taken to seal the shimming

material appropriately.

After the sealant has had an opportunity to set up, trim away all excess material flush with the edges of the sealer

(screed) assembly and touch up any areas where the sealant is not making a perfect seal (Figure 5.).

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104/ 104

Bekijk gratis de handleiding van Master-Bilt QS2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Koelkast