Martin VC-Dot 4 handleiding
Handleiding
Je bekijkt pagina 18 van 28
18 VC-Dots™ user manual
Service and maintenance
Warning! Read “Safety Information” on page 4 before carrying out service on the VC-Dots™
system.
Warning! Isolate the installation from AC mains power before servicing.
Warning! Refer any service operation not described in this manual to a qualified service
technician.
Important! Excessive dust and dirt buildup causes overheating that will damage the product.
Damage caused by inadequate cleaning is not covered by the product warranty.
The user will need to clean the VC-Dots™ system periodically. All other service operations on the
VC-Dots™ system must be carried out by Martin Professional™ or its approved service agents.
Installation, on-site service and maintenance can be provided worldwide by the Martin Professional Global
Service organization and its approved agents, giving owners access to Martin’s expertise and product
knowledge in a partnership that will ensure the highest level of performance throughout the product’s
lifetime. Please contact your Martin supplier for details.
The characteristics of all LEDs change very gradually over extended periods of time, and not all colors
change at the same rate. Rates of change vary depending on factors such as temperature and how
intensively a particular color is used over many thousands of hours. The changes mean that overall light
output and the exact hues obtained from LED-based products can be expected to shift slightly over time.
To help you obtain consistent output despite these changes, Martin P3 software from version 4.1.0 contains
the P3 Fixture Adjuster tool. This feature lets you compensate for changes in LED characteristics and
restore initial output and color authenticity levels. Please contact Martin™ for more details.
Cleaning
Cleaning schedules vary greatly depending on the operating environment. It is therefore impossible to
specify precise cleaning intervals for the VC-Dots™ system. In extreme cases, the product may require
cleaning after surprisingly few hours of operation. Environmental factors that may result in a need for
frequent cleaning include:
• Use of smoke or fog machines.
• High airflow rates (near air conditioning vents, for example).
• Presence of cigarette smoke.
• Airborne dust (from stage effects, building structures and fittings or the natural environment in outdoor
locations, for example).
If one or more of these factors is present, inspect products soon after installing them to see whether
cleaning is necessary. Check again at frequent intervals. This procedure will allow you to assess cleaning
requirements in your particular situation. If in doubt, consult your Martin™ dealer about a suitable cleaning
schedule.
To clean the VC-Dots™ system, use low-pressure compressed air to remove dust and loose particles from
the Dots. If necessary, wipe the Dots with a cloth dampened in a detergent solution. Do not use caustic,
abrasive or solvent-based cleaning products. Do not spray Dots with a high-pressure water jet. Clean other
devices as directed in their user manuals.
Installing new software
It may be necessary to upload new software (i.e. device firmware) to the VC-Feeder if the VC-Feeder and
VC-Dots appear to have a software-related fault or if you want to update to a newer software version.
Software for Martin™ products is available from the Martin website. The VC-Feeder software can be
installed from the P3 System Controller over the P3 data link. See the P3 System Controller user manual for
software installation instructions.
Bekijk gratis de handleiding van Martin VC-Dot 4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin |
| Model | VC-Dot 4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3158 MB |
