Martin P3 PowerPort 500 IP Install handleiding

Niet gecategoriseerd

Martin

28 pagina's

PDF beschikbaar

Handleiding

Martin

P3 PowerPort 2000 and 500 IP Safety, Installation and User Manual 23

Service and maintenance

Warning! Read “Safety Information” on page 4 before carrying out service or maintenance

work.

Disconnect all devices from AC mains power before servicing.

Refer any service operation not described in this user manual to Martin Service or an

authorized Martin service agent.

Important! Excessive dirt buildup causes overheating and will damage the product. Damage

caused by inadequate cleaning is not covered by the product warranty.

The user will need to clean the device periodically. The user can also install firmware in P3 PowerPort

2000 and 500 devices. All other service operations must be carried out by Martin Professional or an

authorized Martin service agent.

Installation, on-site service and maintenance can be provided worldwide by the Martin Professional Global

Service organization and its approved agents, giving owners access to Martin’s expertise and product

knowledge in a partnership that will ensure the highest level of performance throughout the product’s

lifetime. Please contact your Martin supplier for details.

Cleaning

Cleaning schedules vary greatly depending on the operating environment. It is therefore impossible to

specify precise cleaning intervals for devices in the P3 PowerPort family. Cooling fans suck in airborne

dust and smoke particles, and in extreme cases, the product and its air filters may require cleaning after

surprisingly few hours of operation. Environmental factors that may result in a need for frequent cleaning

include:

• Use of smoke or fog machines.

• High airflow rates (near air conditioning vents, for example).

• Presence of cigarette smoke.

• Airborne dust (from stage effects, building structures and fittings or the natural environment in outdoor

locations, for example).

If one or more of these factors is present, inspect products within their first 25 hours of operation to see

whether cleaning is necessary. Check again at frequent intervals. This procedure will allow you to assess

cleaning requirements in your particular situation. If in doubt, consult your Martin dealer about a suitable

maintenance schedule.

To clean a product in the P3 PowerPort family:

1. Shut down power to the device and allow it to cool for at least 15 minutes.

2. Use a vacuum cleaner or low-pressure compressed air to gently remove dust and loose particles from

the outside of the device, paying special attention to fan grills and air vents. Take care not to direct the

vacuum or air jet at cooling fan blades because this can spin the fan too fast and cause damage that

is not covered by the product warranty. You can avoid this problem by holding fans still with a

screwdriver while you are working.

3. Wipe the outside of the device with a cloth lightly moistened in a mild detergent solution. Do not

splash with water. You can rinse an IP66-rated device with water, but do not direct a high-pressure

water jet at the device. Do not use any product that contains abrasives or solvents.

4. Dry the device with a soft cloth before reapplying power.

Pressure equalization valves

Each P3 PowerPort 500 IP device has a pressure equalization valve (see illustrations for each device

earlier in this manual). Check this valve visually from time to time. If it appears to be dirty, consult Martin

Service for possible replacement.

Bekijk gratis de handleiding van Martin P3 PowerPort 500 IP Install, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.