Martin P3 PowerPort 500 IP Install handleiding

Niet gecategoriseerd

Martin

28 pagina's

PDF beschikbaar

Handleiding

22 Martin

P3 PowerPort 2000 and 500 IP Safety, Installation and User Manual

Status LEDs and Test/Reset button

Status information

P3 PowerPort devices give status information via LEDs on their front panels. A key to the status

information given by the LEDs is printed on the device and given below.

For each output:

• The Data LED lights when data is being transmitted at that output.

• The Power LED lights when 48 VDC power is present at that output.

• NET1 and NET2 LEDs light to indicate traffic at the corresponding network data port.

• The LED gives the information in the table below:

Color

Output

Indication

Suggested action

Blue

Constant

Busy (e.g. booting up or writing to

flash memory).

Wait a moment for normal

operation to be resumed.

Green

Constant

P3 protocol detected.

Magenta

Constant

Art-Net or sACN detected.

Red

Flashing

No control source detected (no

protocol detected on Ethernet).

Connect a P3 System Controller,

Art-Net controller or sACN

controller to the network.

Yellow

Constant

Overtemperature.

Allow the device to cool. Clean

the device and improve

ventilation. Press Test/Reset

button to restore functionality.

Red

Constant

Error. The P3 PowerPort has

encountered a fatal error and

cannot run.

Perform a factory reboot. If the

problem persists, carry out a

firmware upload.

Fast RGB

Cycling

Test pattern being sent to

connected products.

Test/Reset button functions

P3 PowerPort devices have test sequences stored in internal memory that you can call up using the

Test/Reset button. The test sequences let you check that the connected creative LED products are set up

correctly without the need for a controller. Note that test patterns can also be called up on P3 system

controllers and on any individual system components that have a test/control button.

The Test/Reset button also lets you reboot the device and restore its factory default firmware if you

suspect that the firmware has been corrupted.

If an output on a P3 PowerPort has been disabled because of an overload or short circuit, pressing the

Test/Reset button will re-enable the output.

The functions of the P3 PowerPort’s single Test/Reset button are printed on the device and given below:

Button action

Function

Repeated short press

Display the following test patterns on all Martin Creative LED

display products that are correctly connected (one short press

scrolls to next pattern): Calibrated mixed White → Full Red → Full

Green → Full Blue → Full White

Press and hold until status

LED lights blue

Reboot the P3 PowerPort.

Press and hold until status

LED lights white

Return the P3 PowerPort to its default factory firmware.

Bekijk gratis de handleiding van Martin P3 PowerPort 500 IP Install, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.