Martin P3 PowerPort 500 IP Install handleiding

Niet gecategoriseerd

Martin

28 pagina's

PDF beschikbaar

Handleiding

Martin

P3 PowerPort 2000 and 500 IP Safety, Installation and User Manual 21

8. Tighten the compression nut B on the network data cable gland R until the cable is held tightly in the

cable gland.

To connect a network data throughput cable, follow the same procedure as for the network data input

cable (see above), using the remaining data cable gland, cable clamp, quick-connectors and screw

terminal.

Status LED and power mode settings

The two switches located inside the connections compartment let you manage the status LEDs and

Test/Reset button on the front panel (switch marked ‘Front Panel On/Off’) and manage the power setting

of connected fixtures (switch marked ‘Power Control/Full/Half’). See ‘Switches’ on page 10 for more

details.

Closing the connections compartment

When you have finished making connections and/or setting the two switches (see above), check that the

connections compartment seal is clean, dry and in perfect condition, then reinstall the cover on the

connections compartment to protect against the entry of water, moisture and dirt.

Operating

When power is applied to the power input cable, the device carries out a short boot procedure and then

becomes operational. There is no power on/off switch.

Status LEDs and Test/Reset button

You can monitor operation via the status LEDs on the front panel if they are activated using the switch

inside the connections compartment.

You can send test patterns to connected Martin Creative LED fixtures and reboot the device using the

Test/Reset button on the front of the device.

See ‘Status LEDs and Test/Reset button’ on page 22 for details of these two features.

Bekijk gratis de handleiding van Martin P3 PowerPort 500 IP Install, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.