Martin P3 PowerPort 500 IP Install handleiding

Niet gecategoriseerd

Martin

28 pagina's

PDF beschikbaar

Handleiding

16 Martin

P3 PowerPort 2000 and 500 IP Safety, Installation and User Manual

Connecting the device

To connect the P3 PowerPort 500 IP Rental, make connections on the rear panel using the markings on

the panel and ‘Rear panel’ on page 13 for reference.

See illustration on right. All

connectors are IP65-rated. The

connectors and the switches are

protected from water and dust by

rubber sealing caps. Keep the

rubber caps installed on all

unused connectors and on the

switches at all times.

Status LED and power mode settings

The two switches located on the rear panel let you manage the status LEDs and Test/Reset button on the

front panel, and manage the power setting of connected fixtures (see ‘Switches’ on page 10).

Operating

When power is applied to the power input cable, the device carries out a short boot procedure and then

becomes operational. There is no power on/off switch.

Status LEDs and Test/Reset button

You can monitor operation via the status LEDs on the front panel if they are activated using the switch on

the rear panel.

You can send test patterns to connected Martin Creative LED fixtures and reboot the device using the

Test/Reset button on the front of the device.

See ‘Status LEDs and Test/Reset button’ on page 22 for details of these two features.

Bekijk gratis de handleiding van Martin P3 PowerPort 500 IP Install, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.