Martin Exterior Projection Pro Compact handleiding

Niet gecategoriseerd

Martin

71 pagina's

PDF beschikbaar

Handleiding

38 Martin

Exterior Projection Pro Compact User Manual, Rev. A

Calibrating the fixture

It is possible to calibrate the fixture’s effects using the Control / Settings DMX channel. You can

calibrate fixtures one at a time or calibrate multiple fixtures if you can see and compare their

projections.

Important! Any calibration adjustments that you make will permanently overwrite the factory

calibration values.

To adjust calibration settings:

1. Apply power to the fixture(s).

2. Select ‘Enable calibration’ on the Control/Settings DMX channel and hold for 5 seconds to

activate. The fixture now registers the current positions of all effects and holds them there. To

select an effect to adjust, you must first release it from its hold position by changing the value on

its DMX channel by +/- 10%. The effect then returns to its hold position. The effect's DMX channel

now represents the full calibration range. The range can vary . Take +/- 5% for instance, in this

case you can adjust the effect’s position using that effect’s DMX channel as follows:

• DMX value 0 = -5%

• DMX value 127= 0%

• DMX value 255= +5%.

3. Adjust the effect until it is in the required position.

4. Send a ‘Store XXX calibration’ command on the Control/Settings channel for each effect that you

adjust and hold that command for 5 seconds to activate. The new calibration offset is now stored

in memory.

5. When you have finished adjusting calibration offsets, send value 0 on the Control/Settings channel

and hold for 5 seconds to exit the DMX calibration procedure and return to normal DMX control.

Bekijk gratis de handleiding van Martin Exterior Projection Pro Compact, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.