Martin Exterior Projection Pro Compact handleiding

Niet gecategoriseerd

Martin

71 pagina's

PDF beschikbaar

Handleiding

Martin

Exterior Projection Pro Compact User Manual, Rev. A 39

Troubleshooting

This section describes some possible problems that you may experience and provides some

suggestions for easy troubleshooting:

Symptom

Potential cause

Remedies

No light from

fixture.

Power supply issue such

as faulty connector or

damaged cable.

Ensure that the mains supply is connected

and supplying power to the fixture. Check all

power connections and cables.

Fixture does not

respond correctly

to DMX control.

Incorrect DMX setup.

Fault in the DMX network

due to connector or cable

damage or potential

interference from proximity

to a high voltage

installation.

Internal fault.

Ensure that fixture’s DMX address matches

address set on DMX control device.

Check that fixture’s status LED shows that it is

receiving DMX. If not, check all DMX cables

and connections.

Ensure that DMX link is terminated.

Check that all components on DMX link use

standard DMX polarity.

Attempt to control the fixture with another

DMX control device.

Move or shield the DMX link if it is close to an

unshielded high-voltage installation.

Contact your Martin authorized distributor or

Martin Global Service for assistance.

Condensation

visible on inside of

front glass.

Humidity inside fixture.

Condensation inside the fixture is normal in

some atmospheric conditions. The fixture will

gradually expel humidity via its Gore-Tex

pressure relief valve as it cycles on and off.

If required, you can remove excessive

humidity by following the directions given in

the section on removing and re-installing the

effects compartment cover in the Safety and

Installation Manual.

Unexpected

behavior in

standalone

operation

More than one fixture set

to SYNC HOST.

Standalone shows in

different fixtures do not

contain the same number

of scenes

Set only one fixture to SYNC HOST, set all

others to SYNC CLIENT.

For perfect standalone show synchronization,

check that all fixtures have the same number

of scenes in their standalone shows.

Bekijk gratis de handleiding van Martin Exterior Projection Pro Compact, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.