Martin Audio iK41 handleiding
Handleiding
Je bekijkt pagina 11 van 61
Back panel
1. Loudspeaker connectors. The amplifier has four
speakON outputs labelled 1, 2, 3 and 4. For details,
see Output connections (page 39).
2. Analogue audio input connectors. All audio
connections are fully balanced and wired: pin 1 to
ground (as required by the AES48 standard), pin 2
hot and pin 3 cold. For details, see
Audio connections
(page 39).
Analogue audio link connectors. Carries a duplicate
(parallel) connection (to another amplifier for
example).
3. AES3 audio input connectors. For inputting digital
audio signals. The Input is fully balanced and wired:
pin 1 to ground, pin 2 data+ and pin 3 data. The link
connector allows a buffered AES3 signal to be passed
on to another device.
4. Dante ports. Primary and Secondary
Dante
ports (page 17).
5. Ethernet port. Use this port to connect your amplifier
and PC so that you can control the amplifier using
Vu-Net (page 36). This software also allows you to
update the amplifier firmware and to integrate with
other Martin Audio products such as MLA and CDD-
Live.
6. Mode. If you press and hold this button for about six
seconds, the unit changes the IP mode to auto and
searches for an IP address. If the IP mode is already
auto, it just searches for an IP address. In both cases,
if the amplifier fails to find an IP address, it allocates
one. You can also change IP mode using the utility
menu (page 33).
7. Six-pin Phoenix connector (also known as a
Euroblock). This has two ports:
▪ The three pins on the left are the AUX
port (page 43). This allows you to control the
amplifier from an external device.
▪ The three pins on the right are the Fault relay
port (page 51). This allows you tomonitorthe
amplifier from an external device.
8. Power Inlet. Connect to a suitable mains electricity
supply using an earthed 32amp powerCON
connection power lead. The device has a switch mode
power supply that is capable of operating with a
nominal mains voltage of 100V to 230V, 50/60Hz
without reconfiguration. For details, see AC power
connection (page 38).
The device must be earthed to a
suitable power earth. Failure to do
so will invalidate the warranty and
could be hazardous. It could also
affect performance and operation.
iK41 User Guide
11
Bekijk gratis de handleiding van Martin Audio iK41, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin Audio |
| Model | iK41 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8458 MB |
